Backup exec updating catalogs

Once your site is upgraded, you need to upgrade the clients and console to SP1. I like to create a collection that targets clients the latest SCCM 2012 R2 SP1 version.

You can manually upgrade by browsing to .\Config Mgr Installation Folder\tools\Console Setup and execute Console on each computer running the console. I use it to monitor which client haven’t been upgraded yet.

Later, the Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) needed only one port for full-duplex, bidirectional traffic.

The even-numbered ports were not used, and this resulted in some even numbers in the well-known port number range being unassigned.

Do I still need to perform the SCCM 2012 R2 SP1 upgrade?

See the full list of features on this Technet Article to figure it out.

Before performing an SCCM 2012 R2 SP1 upgrade, we recommend that you read carefully all the available resources and carefully plan the upgrade process throughout your SCCM 2012 R2 hierarchy.

The Severity column value of 1 is high and 4 is low.

Severity column represents the severity of the PMR at the time the APAR was opened.

Microsoft has recently announced the release of SCCM 2012 SP2 and SCCM 2012 R2 SP1.

This post is covering all the requirements and checklist steps needed if you’re running SCCM 2012 SP1 (non-R2).

If you have a hierarchy with a Central Administration Site and multiple Primary Site, start with the top of the hierarchy (CAS) and go down, upgrading all Primary Sites and Secondary Sites.

Search for backup exec updating catalogs:

backup exec updating catalogs-64

This is a list of TCP and UDP port numbers used by protocols of the transport layer of the Internet protocol suite for the establishment of host-to-host connectivity.

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “backup exec updating catalogs”